NitroData Chip Tuning Box for Motorbikers M2
Why we need to use Nitrodata chip tuning box?
As some motorcycles run richer and others are leaner, we suggest
that you start by using the NitroData with the dial set to minimum
and gradually increase the dial to a higher until you find the
setting which is best for your bike. A slightly modified engine
(sport exhaust, air filter etc.) will generally a better
performance with the dial set around midle if the bike has an
aftermarket exhaust system fitted. A setting between midle and
midle more can be used
When the catalytic converter has been removed. The original
standard performance is to be found at minimum setting on control
If the bike running richer then the setting will probably need to
be set between litle then minimum. You will feel from the
performance of the motorcycle when the engine is running smoothly
and it is not necessary to run a Dyno test. Please avoid falling
into the trap of thinking the higher the maximum the better the
performance as it will vary depending on the bike. If it appears
that you are losing the torque when you hit high speeds this most
probably means that you have set the NitroData number too high and
need to try a lower setting.
What you need to do to use Nitrodata chip tuning box?
To fit the NitroData you will need to locate the air temperature
sensor (IAT) which is located near the air box on most
bikes.Disconnect the plug connectors which are already attached to
the IAT and attach the plug connectors of the NitroData module to
the relevant connector of the IAT. The NitroData is now ready to
What motobike brand it can do?Does it has user manual?
Please check the technical service which next to the description.
NitroData Chip Tuning Box for Motorbikers M2 vehicle list:
Aprilia RSV 1000 / Tuono 04-08
Aprilia RSV 1000R Factory 04-08
Aprilia Tuono 1000 / Tuono 04-08
1pc x NitroData Chip Tuning Box M2